Building the Front Booth

May 18th 2011

In this photo I am starting to build the frame for the booth. I also installed a new circuit breaker so we could start tying the circuits together in the new breaker box.

The picture on the right shows the booth frame that goes in on the right side of the trailer just inside of the door. The frame was built out of solid birch  On the and front I used birch veneer, then used plywood place on the top to hold the cushions in place.







                                                                


                                                              I have completed the booth for the left side of the trailer that fits in next to the stove. all have put the cushions in place. The cushions were made out of 6 inch foam. They are very comfortable and the material used to cover the booth seats matches the seat that I had recovered for my 1965 GMC truck. We are going to use that GMC truck that we are going to use to pull the trailer.

 

This picture shows the completed booth on the right as you come in the trailer door.  The table sets between the two booths. Letting down both booth and rearranging the cushions makes a bed in the front of the trailer.